Capacity
All power take-offs are particularly designed for driving hydraulic pumps to SAE J744C series ‘B’ specification with splined input shaft and either two-bolt or 
four-bolt fixing. The maximum power which can be transmitted is 22 KW (29.5 bhp) per 1000 rev/min engine speed; this compatible a torque of 209 Nm (155 Ibf.ft. – 21.33 kgm.).For PRM1000 the clutched power take-off gives pump rotation the same as the engine, where as the direct drive power take-off for the PRM500 and PRM750 will give opposite rotation. Capacity to the pump isn’t affected by the normal use of the gearbox for propulsion duties. All ancillary power circuits powered by PRM power take-offs should be designed in accordance with the suggestions of the hydraulic tools manufacturer, and should be properly safeguarded against overloading.
Installation
PRM power take-off devices fit on the rear face of the main gearcase and are driven by the insight shaft; consequently they can be operated at all times whilst the engine is certainly running, The energy take-off replaces the end cover which is generally installed and performs the functions of the finish cover by sealing the gearbox against loss of oil and properly positions the input shaft rear bearing. Power take-off units also provide the link between the gearbox and the hydraulic pump.
Direct Drive Power Take-Off
Available on the PRM500 and PRM 750 the immediate drive power take-off is certainly driven directly from the gearbox input shaft; consequently it will operate all the time when the engine is running, and since there is no clutch for disengagement of the hydraulic pump, provision must be made in the auxiliary hydraulics circuits for pressure by-pass to the reservoir when capacity to the pump is not required. A set of 1:1 ratio gears, providing adequate offset between the gearbox output shaft and the centreline of the energy take-off to ensure there is adequate clearance between your hydraulic pump and propeller shaft coupling.
Specifications
Ever-Power PTO Shaft
Series 6
1-3/8 inch 6-spline tractor end yoke and a 1-3/8 inch 6-spline FD2 clutch on the implement end
FD2 clutch
Collapsed length: 47 in.
Extended length: 60 in.
62 HP at 540 RPM
98 HP at 1000 RPM
FD2 clutch attaches with one bolt that suits a groove on input shaft of rotary mower
If you need more information about pto gearbox examine out our website.