rotary cutter gearbox
rotary cutter gearbox
RC-20 Sequence
Requirements
Torque: 1,750 – three,267 lb.-in.
198 – 369 Nm.
Ratios: one:two.five, one:two.83
Seals: Triple Lip Spring Loaded
Bearings: Deep Groove Ball
Oil Cap: 16 oz. (.forty seven L)
Weight: 34 lbs. (15.four kg)
Applications
Ending Mowers Rotary Cutters
Rotary Slashers Toppers
RC-27 Series
RC-thirty Series
Requirements
Torque: two,800 – four,667 lb.-in.
316 – 527 Nm.
Ratios: 1:one.47, one:1.71, 1:1.ninety three
Seals: Triple Lip Spring Loaded
Bearings: Deep Groove Ball
Oil Cap: 23 oz. (.sixty eight L)
Weight: 51 lbs. (23.1 kg)
Purposes
Ending Mowers Rotary Cutters
Rotary Slashers Toppers
RC-51 Series
Technical specs
Torque: 2,800 – 4,667 lb.-in.
316 – 527 Nm.
Ratios: one:1.forty seven, one:one.seventy one, one:one.ninety three
Seals: Triple Lip Spring Loaded
Bearings: Tapered Roller/ Deep Groove Ball
Oil Cap: 27 oz. (.eighty L)
Weight: fifty six lbs. (twenty five.4 kg)
Purposes
Rotary Cutters Rotary Slashers
Gears: Offered with possibly straight bevel or spiral bevel gearing.
Power: Hp & Torque dependent on AGMA formulation for steady responsibility in addition a service or load course issue.
Shafting: Various dimensional, metallurgical, and heat-take care of possibilities obtainable.
Bearings: Geardrives obtainable with various bearing lifestyle alternatives.
Lubrication: Drives available with different lubes depending on running attributes
Alternative Rotary Cutter gearbox, 40hp rated, 1-3/8″-6 spline input shaft, one.fifty seven” X twelve tapered spline output shaft and one:1.forty seven speed up ratio. These gearboxes have a square housing configuration and are identical in mounting and ratio to the round configuration gearboxes. These are unique equipment gearboxes on the IM402, IM502 and IM602 collection rotary cutters which highlighted slip clutch PTO shafts. This gearbox will not match the IM400, IM500 and IM60 models as they have a easy input shaft! If your gearbox has a 12 spline output shaft and a 1-three/8″ – 
6 spline enter shaft this gearbox will perform. Bolt pattern is four-three/4″ on centre hole to gap and six-3/4″ center to center of bolt hole on diagonal. The mounting holes type a sq. bolt pattern.
rotary cutter gearbox
What else would you want to understand about rotary cutter gearbox?