one.A connecting hyperlink of an O-ring Chain for basic application is pre-coated with grease on the pins. Just before connection, confirm the grease within the surfaces of pins, and if the level of grease is little, apply grease with bare hands. (If gloves are utilised, the grease is going to be absorbed through the gloves.)
Instance: Once the connecting hyperlink (I) of an O-ring chain for general application is
shipped, O-rings are fitted with the roots with the pins. In case the O-rings come loose as a consequence of vibration through transport, refit the O-rings in for the roots with the pins.
In this case, you’ll want to return the grease collected on the roots in the pins to the central surfaces with the pins, more at portion A than at portions B shown while in the above illustration. (Portions A is worn on account of sliding using the bushings.)
2.The chain is usually most quickly linked about the teeth of the sprocket. Engage the back links at both ends with the chain with the sprocket teeth and fit connecting pins. When the sprocket could be 
moved, the chain can also be linked around the loosened side.
3. Connecting process
one.Confirm that O-rings are attached towards the roots with the pins.
2.In the event the quantity of grease applied to the connecting pins is compact, coat the pins with grease with the central portions.
three.Insert the connecting pins into the bushings with the inner backlinks at the two ends.
4.Verify the grease is utilized to your total encounter from the O-ring, and match the O-ring onto the connecting pins.
5.Insert the connecting pins into the connecting plate and when pressing the connecting plate, set up the spring clip. Confirm no matter if the head (the finish without a split) in the spring clip is turned from the feeding direction with the chain. (See the following illustration.)
6.Make sure you confirm the spring clip is securely fitted while in the clip grooves of your connecting pins.
This completes jointing with the connecting website link. Note that grease around the surfaces of connecting pins and O-rings is often eliminated all through installation work. In this instance, re-grease using the grease within the surface from the base chain or the grease inside the polyethylene bag through which the connecting link was contained.