one.A connecting link of an O-ring Chain for standard application is pre-coated with grease at the pins. Prior to connection, confirm the grease within the surfaces of pins, and if your level of grease is small, apply grease with bare hands. (If gloves are used, the 
grease will likely be absorbed through the gloves.)
Instance: When the connecting link (I) of an O-ring chain for standard application is
shipped, O-rings are fitted at the roots in the pins. In case the O-rings come loose as a result of vibration all through transport, refit the O-rings in to your roots of your pins.
In this instance, you should definitely return the grease collected on the roots on the pins on the central surfaces from the pins, additional at portion A than at portions B shown from the over illustration. (Portions A is worn as a consequence of sliding together with the bushings.)
2.The chain is often most very easily connected on the teeth of the sprocket. Engage the links at both ends with the chain with the sprocket teeth and fit connecting pins. Should the sprocket is usually moved, the chain may also be connected over the loosened side.
3. Connecting process
one.Verify that O-rings are connected on the roots with the pins.
2.Should the volume of grease utilized on the connecting pins is small, coat the pins with grease on the central portions.
three.Insert the connecting pins in to the bushings on the inner hyperlinks at the two ends.
four.Confirm that the grease is applied on the total encounter from the O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins in to the connecting plate and when pressing the connecting plate, set up the spring clip. Confirm whether the head (the end without a split) from the spring clip is turned within the feeding course of your chain. (See the next illustration.)
six.You’ll want to verify that the spring clip is securely fitted within the clip grooves from the connecting pins.
This completes jointing of the connecting hyperlink. Note that grease over the surfaces of connecting pins and O-rings is often removed during installation operate. In this case, re-grease using the grease within the surface on the base chain or the grease within the polyethylene bag in which the connecting website link was contained.